The video codecs officially supported by Smode are Hap and MOV. So, if you have a video in a different codec in your Media Directories, you may see this warning next to the file.
You can transcode your video into a codec supported by Smode directly internally by right-clicking on the video file and selecting
'Transcode'
.
A pop-up window will open, allowing you to choose the codec in which you want to encode your video.
You can also decide to keep the default frame rate or reinterpret the frame rate by checking the option and choosing a new value.
You can set a begin and end ( they can be also set using the preview panel using the "I" and "O" shortcut)
The resize option allow you to scale the video ( stretch mode ), crop it ( Pixel Perfect mode), or fit inside or outside, the 2 percentage at the end is the fit position like for a
Video Output Device
Video Output Devices are devices that enable the sending of a video stream out of Smode
Read More
( 50%/50% will place the video in the center , 0%/100% will place the video in the bottom left corner)
By default,
'Audio'
is disabled. If you want to encode your video's audio as well, uncheck video and check the audio and select the codec (this to extract the audio form the video.
When you click OK, Smode will start encoding the video. You can track the progress in the
Tasks Panel
Shows the rendering and transcoding tasks currently running in Smode
Read More
.
Once transcoding is complete, a new folder is created with the transcoded video inside.